Best quality and factory Screw Union-Thread End Hawaii Supplier
We take "customer-friendly, quality-oriented, integrative, innovative" as objectives. "Truth and honesty" is our management ideal. Best quality and factory Screw Union-Thread End Hawaii Supplier, We encourage you to make contact as we are looking for partners in our venture. We are sure you will find doing business with us not only fruitful but also profitable. We are ready to serve you with what you require.
How to assemble check valves on the Antec LC110S pump.
Sea foam is for any gas, diesel, biodiesel, and ethanol engines.
Sea foam can be used on
Inboard boat engines
Outboard boat engines
Sea foam cleans intake valves and pistons, cleans catalytic converter odors, restores power and pickup, cleans carbon buildup, gives smoother idle and cures hesitations and pings and removes moisture from oil and gas
Sea foam goes into your engine various way and is quite thorough
1/3 of the 16 fl oz bottle goes into your gas tank, 1/3 goes into your oil cap, and 1/3 goes into your vacuum lines.
After you put Sea foam into your gas and oil start your engine and let your vacuum lines sip it for a couple seconds at a time and then stick vacuum line completely submerged in sea foam until the engine dies or bottle is gone(NOTE: have a friend on standby to turn the engine off after the engine chugs the sea foam)
And let the car sit for 5-30 minutes. 5 minutes is optimal. And start the engine afterwards and let it idle for a minute or two and then rev it a good amount. You will see lots of white smoke, if you are sea foaming a car. Go drive it, best at night. The white smoke is usually thick and may get you stopped by law enforcement officers so do it safely and the right way.
A JOB WORTH DOING IS WORTH DOING RIGHT!